This forum is in support of advanced, high performance concrete made with products from Blueconcrete.com. We are promoting our system approach called the "Z" System, with color, admixtures, reactive sealing technology, and advanced mix designs.
K making some furniture for outdoors. My concerns is it is hot in Texas as you may know or perceive. Is there a way to make the concrete chair more repellent to heat? Top coat or something? Any help is much appreciated.
Does anyone have a signed agreement for products that are loaned to a showroom?I'm looking at loaning one of my large vanities with waterfall legs and a vessel bowl to a local showroom. Since it's worth 4 or 5x more than my typical showroom sinks I…Continue
Over the last few weeks I have been trying to tweak the ZFRC mix, which is f-ing perfect for spraying and backers, to do some wet casting of tiles. Just to save some cost on production and try to hit some what turns out to be unrealistic pricing out…Continue
What's the best way to get ch and fs on a very rough side profile? Wouldn't be so worried with a thinner piece but this is a 6 inch drop edge and a rough textured front? I realize it has to be thin coats of both ch and fs and can't seem to think of…Continue
Ok so here is a pretty decent looking kitchen but I am going to be recasting the whole thing because there are too many large compromises to ask of the home-moaner. Here is the recipe I got from the forum here on how to manipulate a bag of…Continue
Hi FolksI followed the recomended gfrz recipe for a job. I was left with 20% of concrete left over.It happened to me before and only when i use liquidz+. Is it normal? Anyone experience the same thing? All my parts are 3D design on computer and the…Continue
Hi Folks. We are doing a large curved buffet top for a Delta hotel in Victoria BC. It is to be 1" thick and supported by the millwork. I just learned it is going to have three heaters located in the under side that will heat the counter in those…Continue
Basically speaking I want to eliminate spraying as much as I can but if I simply cast my concrete(gfrc) then I run a risk of fibers showing while processing. Are the pvs's less visible when processing and can they replace glass fibers?I thought…Continue
Posted by Daniel Miano on April 15, 2014
Posted by Ian Wyndlow on April 3, 2014
Posted by nathan hake on April 10, 2014
Posted by nathan hake on April 3, 2014
Posted by Nathan M Miles on April 21, 2014